Center Console Removal/Installation

Center Console Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014*
* Available through the American Honda Tool and Equipment Program; call 888-424-6857

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the front seat, dashboard, and related parts.

1. Remove the dashboard center lower cover.




2. Detach the clips, then remove the console trim (A). Disconnect the subharness connectors (B), and detach the harness slip.




3. Pull the center floor tray (A) up by hand to detach the clips, then remove it.




4. Remove the bolts (A) and screws (B), then remove the center console (C).
5. Install the console in the reverse order of removal, and note these items.
- Replace any damaged clips.
- Make sure the connectors are plugged in properly.