Glove Compartment: Service and Repair

Glove Box Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
*Available through the American Honda Tool and Equipment Program.

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:
- Take care not to scratch the dashboard and related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.




1. Detach the hook (A) of the glove box damper (B), and remove the screws.




2. While holding the glove box (A), release the glove box stop (B) on each side from the dashboard by pushing them in, then remove the glove box.




3. Open the passenger's door, and gently pull out on the front of the dashboard side cover (A) to release the hooks (B), and remove the cover.




4. Remove the screw, then remove the glove box damper (A).
5. Install the glove box in the reverse order of removal.