Torque Specifications
Cylinder HeadMeasure the diameter of each cylinder head bolt at point A and point B.
If either diameter is less than 10.6 mm (0.42 in.), replace the cylinder head bolt.
Tighten the cylinder head bolts in sequence 39 N-m (4.0 kgf-m, 29 lbf-ft).
After torquing, tighten all cylinder head bolts in two steps (90° per step). If you are using a new cylinder head bolt, tighten the bolt an extra 90°.
Intake Manifold
Tighten the bolts and nuts in a crisscross pattern in two or three steps, beginning with the inner bolt.
Main Bearing Cap
1st Tighten the bearing cap bolts, in sequence 29 N-m (3.0 kgf-m, 22 lbf-ft).
Tighten the bearing cap bolts an additional 56°.
2nd Tighten the 8 mm bolts, in sequence 22 N-m (2.2 kgf-m, 16 lbf-ft)
Connecting Rod Cap
Tightening Torque 20 N-m (2.0 kgf-m, 14 lbf-ft.) + 90°
Crankshaft Pulley
Tighten the bolt 49 N-m (5.0 kgf-m, 36 lbf-ft)
Tighten the pulley bolt an additional 90°.
Oil Pump
Exhaust Manifold
Install the exhaust manifold, and tighten the bolts and nuts in a crisscross pattern in two or three steps, beginning with the inner nut.
Water Pump
