Park Pin Switch Test

Park Pin Switch Test
1. Remove the center lower covers.
2. Disconnect the D3 switch/park pin switch/A/T Gear Position indicator panel light connector.





3. Shift the shift lever into the P position, and check for continuity between D3 switch/park pin switch/A/T gear position indicator panel light connector terminals No. 1 and No. 2.
There should be no continuity.

4. Shift out of the P position, and check for continuity between connector terminals No. 1 and No. 2. There should be continuity.
5. If the park pin switch tests OK, connect the connector and install the center lower covers.
If the park pin switch fails the test, replace the park pin switch.