Tire Pressure Sensor Location
Tire Pressure Sensor LocationSpecial Tools Required
TPMS sensor initializer tool AKS0620006
Available through the American Honda Tool and Equipment program, 888-424-6857.
This procedure locates where tire pressure sensors 1, 2, 3, and 4 are mounted.
When the activate sensor signal is sent to each wheel using the TPMS sensor initializer tool in sequence, you can locate the tire pressure sensors by the reaction sensor number.
The sensor locations change in these cases:
^ Memorizing tire pressure sensor IDs (including replacing the TPMS control unit or the tire pressure sensors).
^ Doing a tire rotation.
1. With the ignition switch OFF, connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle and the TPMS control unit. If it doesn't, troubleshoot the DLC circuit.
4. Follow the prompts on the HDS to active the tire pressure sensors using the TPMS sensor initializer tool. Start with the left-front (LF) wheel.
NOTE:
^ See the HDS Help menu for specific instructions.
^ Initialize the wheels in the sequence shown.
5. Check the HDS screen, and note the active sensor reception order of tire pressure sensors 1, 2, 3, and 4.
NOTE: An example is shown. The sensor signals are received by the TPMS control unit in this order; sensor 1-fourth, sensor 2-second, sensor 3-third, and sensor 4-first.
6. Note the sensor location for reference.
7. Turn the ignition switch OFF.