Washer Fluid Level Switch Test
Washer Fluid Level Switch TestCanada models
1. Remove the right inner fender.
- 2-door
- 4-door
2. Disconnect the 2P connector (A) from the washer fluid level switch (B).
3. Remove the washer fluid level switch from the washer reservoir.
NOTE: Fluid may flow out of the opening.
4. Check for continuity between the NO.1 and NO.2 terminals in each float position.
- There should be continuity when the float is down.
- There should be no continuity when the float is up.
5. If the continuity is not as specified, replace the switch.