Trim Removal/Installation - Tailgate Area
Trim Removal/Installation - Tailgate AreaSpecial Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to bend or scratch the trim and panels.
1. Remove the tailgate weatherstrip as needed.
2. Remove the tailgate handle knob (A), and remove the screw.
3. Open the tailgate. Starting at the bottom edge on the tailgate lower trim panel (A), pull the trim panel up to detach the clips.
4. Close the tailgate half-way and hold it there to loosen the tailgate support cables (A) on both sides. Pull up on the bottom edge of the trim panel (B)and pass the cables under the trim panel on each side.
5. Pull the trim panel (A) out to release the pins (B) of the trim panel and the tailgate handle lever (C), then remove the trim panel.
6. Install the trim panel in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Make sure the tailgate handle lever is slipped through the slit of the trim panel properly.
- Push the clips into place securely.