Carpet: Service and Repair

Floor Covering Replacement

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.

SRS components are located in this area. Review the SRS component location and the precautions and procedures before doing repairs or service.

NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to damage, wrinkle or twist the floor covering.
- Be careful not to damage the dashboard or other interior trim pieces.

Front Floor Covering

1. Remove these items:
- Front seats, both sides
- Door sill trim, both sides
- Kick panels, both sides
- Passenger's dashboard undercover
- Center lower cover
- Center console
- Subwoofer




2. Remove the front floor covering (A).
1. Remove the clips.
2. Release the velcro fastener (B), then pull back the floor covering from under the heater unit.
3. Release the velcro fasteners (C) on the front edge of the floor covering, then pull back the floor covering from under the dashboard.

3. Remove the front floor covering.
4. Install the floor covering in the reverse order of removal, and note these items:
- Take care not to damage, wrinkle or twist the floor covering.
- Make sure the seat harnesses are routed correctly.
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.

Rear Floor Covering

1. Remove these items:
- Front seats, both sides
- Door sill trim, both sides
- Rear side trim panel, both sides
- Center console




2. Remove the clips, then remove the rear floor covering (A).
3. Install the floor covering in the reverse order of removal, and note these items:
- Take care not to damage, wrinkle or twist the floor covering.
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.