Center Console

Center Console Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.

SC Model

NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the center console, dashboard, and related parts.

1. Pull up on the parking brake lever fully.




2. Push and pull the hook (A) of the beverage holder (B) up, then remove it.




3. Remove the front trim mat (A). Pull the rear portion of the center console front trim (B) up to detach the clips (C) and hook (D), then pull it backward to release the clips (E) and remove it.




4. Remove the center console rear trim (A).
1. Open the armrest, and remove the bolt (B) from the bottom of the trim.
2. Pull the right side portion of the trim up to release the hooks (C) and clips (D).
3. Pull the left side portion of the trim up to detach the clips (E) and hooks by pulling the trim up by hand securely.
4. Remove the trim away from the parking brake lever.




5. Disconnect the accessory socket connector (A) from the bottom of the center console. Remove the bolts (B, C).




6. Remove the console box mat (A) and bolts.




7. Lift up the rear of the console, and pull it backward to release the pins (A) and clips from the dashboard, then remove the center console (B).




8. Remove the tray mat (A). Pull the rear portion of the center floor tray (B) up and backward to release the clips (C, D) and remove it from the subwoofer.
9. Install the console in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips and hooks into place securely.
- Make sure the accessory socket connector is plugged in properly.

LX, EX Models

NOTE: Take care not to scratch the front seat and related parts.




1. Pull the front edge Of the center console (A) to release the clips, and remove the console by releasing the hooks (B).
2. Install the console in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clip portions into place securely.