Sun Visor: Service and Repair

Sunvisor Removal/Installation




1. Release the tabs (A) on both sides with the appropriate tool from the KTC trim tool set, then remove the sunvisor cap (B) from the bracket (C). Turn the cap, and remove it.




2. Remove the sunvisor (A).
1. Remove the sunvisor from the holder (B).
2. Using a T25 TORX bit, remove the screws.
3. Remove the sunvisor from the body.




3. Using a flat-tip screwdriver, push the hook (A), and turn the holder (B) 90 °, then pull it out.




4. Install the sunvisor in the reverse order of removal, and note these items:
- If the side curtain airbag has deployed, replace the sunvisor with a new one.
- To prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect removed pieces and replace them if they have any of these types of damage:
- Any cracks in the sunvisor stay base (A)
- Any bends or cracks in the sunvisor stay shaft (B)
- Any cracks in the sunvisor base (C)
- If the threads on a visor screws are worn out, use an oversized self-tapping ET screw, P/N 90137-S30-003, made specifically for this application.