Trim Removal/Installation - Rear Side Area
Trim Removal/Installation - Rear Side AreaSpecial Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
Rear Side Trim Panel
NOTE:
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to bend or scratch the trim and panels.
1. Remove these items:
- Door sill trim
- Rear seat
- Hatch weatherstrip, as needed
- Cargo area floor
2. Remove the lower anchor bolt (A) and tie down hooks (B).
3. Remove the rear side trim panel (A).
1. Remove the screws (B, C) and release the clips (D).
2. Remove the seat belt lid (E) from the rear side trim panel.
3. Pull the upper edge of the panel back to release the upper hooks (F) from the quarter pillar trim (G).
4. Detach the clips (H, I) and pull the panel back to remove it.
5. Passenger's side: Disconnect the accessory power socket connector (J).
4. Install the panel in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- When installing the panel, make sure there are no pinches in the seat belt.
- Push the clips into place securely.
- Before installing the anchor bolt, make sure there are no twists or kinks in the seat belt.
- Make sure the each connector is plugged in properly.