Steering Column Removal and Installation

Steering Column Removal and Installation
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

Removal
1. Make sure you have the anti-theft code for the audio system, then write down the audio presets.
2. Make sure the ignition switch is OFF, then disconnect the negative cable from the battery.
3. Remove the driver's airbag assembly and the steering wheel.
4. Remove the driver's dashboard lower cover.
5. Remove the column covers (A).





6. Disconnect the wire harness connectors from the combination switch assembly (B).
7. Remove the combination switch assembly from the steering column shaft by removing the screw (C) on the top of the combination switch.
8. Disconnect the connectors from the ignition switch, and release the wire harness clips (D) from the steering column.
9. Remove the steering joint bolts, then disconnect the steering joint (E) from the pinion shaft.
10. Remove the steering column (F) by removing the attaching nuts and bolts.

Installation
1. Install the steering column in the reverse order of removal, and note these items:
^ Take care not to let the sliding capsules fall out of position during column installation.
^ Make sure the wires are not caught or pinched by any parts.

2. Insert the upper end of the steering joint onto the steering shaft (A) (line up the bolt hole (B) with the flat portion (C) on the shaft).





3. Slip the lower end of the steering joint onto the pinion shaft (D) taking care to align gap it lower end of steering joint with the tab (E) of the center guide. Punch mark (F) on the pinion shaft (line up the bolt hole with the groove (G) around the shaft), and loosely install the lower joint bolt. Be sure that the lower joint bolt is securely in the groove of the pinion shaft.
4. Pull on the steering joint to make sure that the steering joint is fully seated. Then install the upper joint bolt and tighten it to the specified torque.
5. Tighten the lower joint bolt to the specified torque.
6. Install the steering wheel.
7. Reconnect the negative cable to the battery, and do these items:
^ Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
^ Do the power window control unit reset procedure.
^ Enter the anti-theft code for the audio system, then enter the customer's audio presets.
^ Set the clock.
^ Make sure the horn and turn signal for proper operation.
^ Make sure the steering wheel switches work properly.
^ Make sure the steering wheel is centered.