B1277

DTC B1277: Headlight Switch AUTO Position Circuit Malfunction

Touring Model

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF, and then back ON (II), and wait for 2 seconds.
3. Turn the light switch (AUTO position) ON and wait for 2 seconds.
4. Check for DTCs with the HDS.

Is DTC B1277 indicated?

YES - Go to step 5.

NO - Intermittent failure, the combination light switch and the combination switch control unit are OK at this time. Check for loose or poor connections at the combination light switch connector, and at the combination switch control unit connector.

5. Turn the ignition switch OFF.
6. Disconnect the combination light switch 12P connector from the wiper/washer switch.
7. Perform the combination light switch test. Combination Light Switch Test/Replacement

Is the combination light switch OK?

YES - Faulty combination switch control unit, replace the wiper/washer switch.

NO - Replace the combination light switch.