B2075
DTC B2075: Right Power Sliding Door Switch (Open Side) Signal ErrorNOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF, and then back ON (II).
3. Turn the power sliding door main switch ON.
4. Check for DTCs with the HDS.
Is DTC B2075 indicated?
YES - Go to step 5.
NO - Go to step 9.
5. Turn the ignition switch OFF.
6. Disconnect the 22P connector from the right power sliding door control unit.
7. Remove the power sliding door switch, and disconnect the 10P connector from the switch.
8. Check for continuity between the power sliding door switch 10P connector No. 4 terminal and body ground.
Is there continuity?
YES - Repair a short in the wire.
NO - Go to step 11.
9. Push and hold the open side of the right power sliding door switch for more than 3 seconds.
10. Check for DTCs with the HDS.
Is DTC B2075 indicated?
YES - Go to step 11.
NO - Intermittent failure. The power sliding door system is OK at this time. Check for loose or poor connections at the right power sliding door control unit connector, and at the power sliding door switch connector.
11. Check for continuity between the power sliding door switch 10P connector No. 8 terminal and body ground.
Is there continuity?
YES - Repair a short in the wire.
NO - Go to step 12.
12. Check for continuity between above terminals of the power sliding door switch 10P connector.
Is there continuity?
YES - Replace the power sliding door switch.
NO - Replace the right power sliding door control unit.