B2084

DTC B2084: Right Power Slide Motor Electromagnet Clutch Circuit Malfunction

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A.

1. Turn the ignition switch OFF, and then back ON (II).
2. Turn the power sliding door main switch ON.
3. Operate the open side of the right power sliding door switch four or more times.
4. Clear the DTCs with the HDS.
5. Check for DTCs with the HDS.

Is DTC B2084 indicated?

YES - Go to step 6.

NO - Intermittent failure, the power sliding door system is OK at this time. Check for loose or poor connections at the right power sliding door control unit connector, and at the right power slide motor connectors.

6. Turn the ignition switch OFF.
7. Disconnect the 22P connector from the right power sliding door control unit.
8. Disconnect the 6P connector from the right power slide motor assembly.




9. Check for continuity between the right power sliding door control unit connector A (22P) No. 10 terminal and right power slide motor connector B (6P) No. 1 terminal.

Is there continuity?

YES - Go to step 10.

NO - Repair a short in the wire.




10. Check for continuity between the right power sliding door control unit connector A (22P) No. 22 terminal and right power slide motor connector B (6P) No. 2 terminal.

Is there continuity?

YES - Go to step 11.

NO - Repair an open in the wire.




11. Check for continuity between the right power sliding door control unit connector A (22P) No. 10 and No. 22 terminals and body ground.

Is there continuity?

YES - Repair a short in the wire.

NO - Go to step 12.




12. At the motor side, check for continuity between the right power slide motor connector B (6P) No. 1 and No. 2 terminals and body ground.

Is there continuity?

YES - Replace the right power slide motor assembly.

NO - Go to step 13.




13. At the motor side, check for continuity between the right power slide motor connector B (6P) No. 1 and No. 2 terminals.

Is there continuity?

YES - Replace the right power sliding door control unit.

NO - Replace the right power slide motor assembly.