Latch Position Switch Test
Latch Position Switch Test1. Remove the sliding door panel.
2. Disconnect the rear latch assembly connector (B) 6P.
3. Check for continuity between the terminals in each switch position according to the table.
NOTE:
- The half latch switch turns ON between half and full latch position.
- The full latch switch turns ON between half and full latch position.
- The ratchet switch turns ON at half and full latch position, and turns OFF when the handle is pulled.
- The base switch turns ON with the closer motor operation, then goes OFF when the closer motor returns to its base position.
4. If the continuity is not as specified, replace the latch assembly.