Dashboard Center Panel

Dashboard Center Panel Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

NOTE:
- Take care not to scratch the dashboard and related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Be very careful not to bend the trim.

1. Open the upper glove box.




2. Gently pry up on the dashboard center panel (A) to release the clips.




3. Pry up on the outside edge of the dashboard center panel (A) very carefully to detach the clips (B, C), then remove the panel.
4. Disconnect the hazard warning switch/passenger's airbag off indicator connector (D), climate control unit connector (E), and interior lights switch connector (F).




5. If necessary, remove the screws securing the driver's center vent (A), then separate it from the dashboard center panel (B).
6. Install the panel in the reverse order of removal, and note these items;
- Make sure all connectors are plugged in properly.
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips and hooks into place securely.