Sliding Door Rear Latch
Sliding Door Rear Latch ReplacementNOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the door.
1. Remove the door glass.
2. Release the cable holder (A), and disconnect the failsafe lower cable (B) and rear latch cable (C).
3. Detach the cable clips (D).
4. Disconnect the rear latch assembly connectors (A), and release the hook (B).
5. Remove the bolts (C, D), and loosen the bolt (E), then remove rear latch (F).
6. Do the sliding door cable adjust on the following cables:
- Failsafe cable
- Rear latch cable
7. Install the rear latch in the reverse order of removal, and note these items:
- Make sure the connectors are plugged in properly, and the cables are routed properly and connected securely.
- Take care not to bend any of the cables.
- Make sure the door locks and opens properly.
- When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
- Check for water leaks.