Second Row Seat-Back Cover

Second Row Seat-back Cover Replacement

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the body or tear the seat covers.
- Put on gloves to protect your hands.

1. Fold the seat-back forward.
2. Remove the second row seat.
3. Remove the head restraint.
4. Remove the seat-back.
5. Remove the armrests from both sides.




6. Pry off the caps (A) and remove the screws, then remove the grab handle (B).




7. Remove the third row seat access knob (A) and screw, then remove the third row seat access trim (B).




8. Pull the seat-back cover (A) off the frame hooks (B) around the third row seat access knob (C).




9. Unzip the bottom of the seat-back cover (A).




10. Release the clips fastening the seat-back cover (A) to the frame.




11. While pulling back the seat-back cover, release the inside springs (A) from behind the seat-back.




12. Pinch the tabs on the ends of the head restraint guides (A), and remove them from the seat-back.




13. Pull back the edge of the seat-back cover all the way around, and release the clips (A), then remove the seat-back cover.




14. Remove the seat-back pad (A) from the seat-back frame (B).




15. Right second row seat: If necessary, remove the seat-back damper (A) from the seat-back frame.




16. Install the cover in the reverse order of removal, and note these items:
- To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the clips, hooks, and inside springs.
- Using commercially available upholstery ring pliers (A), replace all the clips you removed with new ones (B).