Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously. (I know, we said we wouldn't ask any more...but it's important!)
J35A6 Engine
Cylinder Head Cover Installation1. Check the spark plug seals for damage. If any seal is damaged, replace it.
2. Thoroughly clean the head cover gasket and the groove of the cylinder cover.
3. Install the head cover gasket (A) in the groove of the cylinder head cover (B). Make sure the head cover gasket is seated securely.
4. Clean the head cover contacting surfaces with a shop towel.
5. Set the spark plug seals (A) on the spark plug tubes, and install the cylinder head cover (B).
6. Inspect the cover washers (C). Replace any washer that is damaged or deteriorated.
7. Tighten the bolts in two or three steps. In the final step tighten all bolts, in sequence, 12 N.m (1.2 kgf.m, 8.7 lbf.ft).
8. Tighten the harness holder mounting bolts (A) and the power steering hose bracket mounting bolt (B).
9. Install the engine ground cable (C) and breather hose (D), then install the harness (E) to the rear upper cover.
10. Connect the three injector connectors.
11. Tighten the two bolts (A) securing the harness holder, and install the harness clamp (B).
12. Install the dipstick.
13. Install the six ignition coils.
14. Install the intake manifold.