Alarm Module: Service and Repair

Immobilizer Control Unit-Receiver Replacement

1. Remove the driver's dashboard lower cover.
2. Remove the steering column covers.




3. Disconnect the 7P connector (A) from the immobilizer control unit-receiver (B).
4. Remove the two screws and the immobilizer control unit-receiver from the ignition key cylinder (C).
5. Install the immobilizer control unit-receiver in the reverse order of removal.
6. After replacement, check the immobilizer system.
7. Using the HDS, select "Immobilizer Setup" from the "Honda System" menu, then select "Immobilizer control unit/receiver replacement".
8. Rewrite the immobilizer control unit-receiver by following the instructions on the HDS, then check the immobilizer system.