SRS Unit Replacement

SRS Unit Replacement

Removal

1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
2. Disconnect both seat belt tensioner connectors.
3. Remove the driver's dashboard lower cover.
4. Remove the driver's and passenger's heater covers.
5. Remove the dashboard center lower cover.
6. Remove the heater lower ducts.




7. Disconnect the three connectors (A) and remove the TORX bolts (B), then pull out the SRS unit.

Installation




1. Install the new SRS unit (A) with TORX bolts (B), then connect the connectors (C) to the SRS unit; push them into position until they click.

NOTE: Be sure the SRS unit is sitting squarely against its bracket before torquing the TORX bolts.

2. Reconnect both seat belt tensioner connectors.
3. Reconnect the negative cable to the battery.
4. Install all removed parts.
5. After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.