Disconnecting System Connectors

Disconnecting System Connectors




Turn the ignition switch OFF, disconnect the negative cable from the battery, and wait at least 3 minutes before beginning the following procedures.

- Before disconnecting the cable reel 4P connector (1), disconnect the driver's airbag 4P connector (2).
- Before disconnecting SRS unit connector B from the SRS unit, disconnect both seat belt tensioner 2P connectors (3,4).

1. Disconnect the negative cable from the battery, and wait at least 3 minutes.

Driver's Airbag




2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) from the cable reel.

Front Passenger's Airbag




3. Remove the lower glove box, then disconnect the front passenger's airbag 4P connector (A) from the dashboard wire harness.

Side Airbag




4. Disconnect the side airbag 2P connector (A) from the floor wire harness.

Side Curtain Airbag

5. Remove the headliner.




6. Disconnect the side curtain airbag 2P connector (A) from the left or right side curtain airbag harness.

Seat Belt Tensioner




7. Remove the B-pillar lower trim. Disconnect the floor wire harness 4P connector (A) from the seat belt tensioner.

SRS Unit




8. Remove the driver's dashboard lower cover. Remove the driver's and passenger's heater covers. Remove the dashboard center lower cover. Remove the heater lower ducts. Disconnect the SRS unit connector A (28P), SRS unit connector B (28P) and SRS unit connector C (16P) from the SRS unit.