Under-hood Fuse/Relay Box

Removal and Installation

Removal

1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the channels for the radio station and XM channel presets. Make sure the ignition switch is OFF.
2. Disconnect the negative battery cable, then disconnect the positive cable, and wait at least 3 minutes.




3. Remove the screws (A) for the alternator and battery cable terminals from the under-hood fuse/relay box.
4. Remove the two mounting bolts (B) from the under-hood fuse/relay box.
5. Remove the bottom cover from the under-hood fuse/relay box.
6. Disconnect the connectors from the under-hood fuse/relay box.
7. Carefully remove the relays by prying under the base of the relay.

NOTE: Do not use pliers; pliers will damage the relays, which could cause the engine to stall or not start.

Installation

1. Install the relays and connect the connectors to the under-hood fuse/relay box, then install the under-hood fuse/relay box in the reverse order of removal.
2. Install the removed parts in the reverse order of removal.
3. Connect the positive cable to the battery, then connect the negative cable to the battery.
4. Do the idle learn procedure.
5. Enter the anti-theft codes for the radio and navigation system, then enter the customer's radio station and XM channel presets.
6. Reset the clock.
7. Do the power window control unit reset procedure.
8. Confirm that all systems work properly.