A/T Clutch Pressure Control Solenoid Valve A and B Replacement
A/T Clutch Pressure Control Solenoid Valve A and B Replacement1. Make sure you have anti-theft code for the audio unit and navigation system, then write down the audio presets.
2. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
3. Remove the battery hold-down bracket, the battery and the battery tray.
4. Remove the engine cover and the air cleaner assembly.
5. Remove the battery base.
6. Remove the nuts securing the shift cable bracket (A).
7. Remove the spring clip (B) and the control pin (C), then separate the shift cable end (D) from the control lever (E).
8. Remove the bolt securing the harness cover (A).
9. Remove the harness cover/clamp bracket (B), disconnect the 4th clutch transmission fluid pressure switch connector (C), then remove the harness cover from the bracket.
10. Disconnect the A/T clutch pressure control solenoid valve A connector (D), the A/T clutch pressure control solenoid valve B connector (E), the solenoid harness connector, the transmission range switch connector, the ATF temperature sensor connector, the output shaft (countershaft) speed sensor connector, the input shaft (mainshaft) speed sensor connector, and the 3rd clutch transmission fluid pressure switch connector.
11. Remove A/T clutch pressure control solenoid valves A and B, the ATF pipes (C), the gasket (D), and the 0-rings (E). Note the lengths and locations of the ATF pipes.
12. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust and dirt, and clean the passage if necessary.
13. Install a new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing. Install the new 0-rings over the ATF pipes.
14. Install A/T clutch pressure control solenoid valves A and B.
15. Install the harness cover on the cover bracket, and secure it with the bolt.
16. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely. Install the harness clamp on the bracket.
17. Attach the shift cable end to the control lever, then insert the control pin into the control lever hole through the shift cable end, and secure the control pin with the spring clip.
18. Secure the shift cable bracket with the nuts.
19. Install the battery base.
20. Install the air cleaner assembly and the engine cover.
21. Install the battery tray, the battery, and the battery hold-down bracket, then connect the battery terminals.
22. Enter the anti-theft code for the audio unit and navigation system, then enter the audio presets, and set the clock.