DTC 11-9x

DTC 11-9x ("x" can be 0 thru 9 or A thru F) Short to Ground in Driver's Airbag First Inflator

DTC 11-Bx ("x" can be 0 thru 9 or A thru F) Short to Ground in Driver's Airbag Second Inflator

Special Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead F 07XAZ-SZ30100

1. Erase the DTC memory .
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC 11-9x or 11-Bx indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. Troubleshooting Intermittent Failures If another DTC is indicated, go to the DTC Troubleshooting Index. DTC List - Supplemental Restraint System

3. Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.




4. Disconnect the driver's airbag 4P connector (A) from the cable reel.
5. Connect the SRS inflator simulator (2 ohm connectors) and simulator lead F to the cable steel.
6. Reconnect the negative cable to the battery.
7. Erase the DTC memory.
8. Check for a DTC.

Is DTC 11-9x or 11-Bx indicated?

YES - Go to step 9.

NO - Short to ground in the driver's airbag first or second inflator replace the driver's airbag.

9. Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.




10. Disconnect the dashboard wire harness A 4P connector (A) from the cable reel.
11. Connect the SRS inflator simulator (2 ohm connectors) and the simulator lead to dashboard wire harness A.
12. Reconnect the negative cable to the battery.
13. Erase the DTC memory.
14. Check for a DTC.

Is DTC 11-9x or 11-Bx indicated?

YES - Go to step 15.

NO - Short to ground in the cable reel replace the cable reel.

15. Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.
16. Disconnect SRS unit connector A (28P) from the SRS unit.
17. Disconnect the SRS inflator simulator from the SRS simulator lead. Do not disconnect the simulator lead from the dashboard wire harness A 4P connector.




18. Check resistance between each terminal of both SRS simulator leads and body ground. There should be an open circuit or at least 1 M ohm.

Is the resistance as specified?

YES - Faulty SRS unit replace the SRS unit.

NO - Go to step 19.




19. Disconnect SRS subharness 28P connector C821 (B) from dashboard wire harness A connector C821.




20. Check resistance between the No. 3 terminal of SRS subharness 28P connector C821 and body ground, the No. 4 terminal and body ground, the No. 9 terminal and body ground, and No. 10 terminal and body ground. There should be an open circuit or at least 1 ohm).

Is the resistance as specified?

YES - Short to ground in dashboard wire harness A replace dashboard wire harness A.

NO - Short to ground in the SRS subharness replace the SRS subharness.