Center Panel

Center Panel Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the dashboard and related parts.

1. Remove the left middle panel.




2. On the driver's side, gently pull out on the panel (A) to detach the side clips, then remove the panel.




3. Disconnect the multi switch two connectors (A).
4. Install the panel in the reverse order of removal, and note these items:
- Make sure each connector is plugged in properly.
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.