A/T Clutch Pressure Control Solenoid Valve C Replacement

A/T Clutch Pressure Control Solenoid Valve C Replacement
1. Remove the intake manifold cover and the intake air duct.
2. Disconnect the A/T clutch pressure control solenoid valve C connector.





3. Remove A/T clutch pressure control solenoid valve C.
4. Remove the ATF joint pipes, O-rings, ATF pipe, and gasket.
5. Clean the mounting surfaces and fluid passages of the solenoid valve body and the transmission housing.
6. Install the 8 x 53 mm ATF joint pipe (A) with the filter end into its mounting hole (B).





7. Check the height (A) of the 8 x 53 mm ATF joint pipe (B) between the top (C) of the pipe and the solenoid valve body mounting surface (D). The height is about 7 mm (0.3 in.) If the height is over 7 mm (0.3 in.), push the pipe until it bottoms in the accumulator body.





8. Install the new gasket (A) on the transmission housing, and install the 8 x 34.5 mm ATF joint pipe (B) with the filter end in the transmission housing and 8 x 25.2 mm ATF pipe (D).





9. Install new O-rings (E) over the ATF joint pipes.
10. Install A/T clutch pressure control solenoid valve C.
11. Install the intake air duct and the intake manifold cover.