Removal and Replacement
Starter Removal and InstallationRemoval
1. Make sure you have the anti-theft codes for the audio unit (and navigation code if equipped), then write down the audio presets.
2. Disconnect the negative cable from the battery first, then disconnect the positive cable.
3. Remove the battery.
4. Remove the automatic transmission fluid (ATF) dipstick.
5. Remove the harness clamp (A).
6. Disconnect the starter cable (B) from the B terminal, then disconnect the BLK wire (C) from the S terminal.
7. Remove the two bolts holding the starter.
Installation
1. Install the starter (A) using a new gasket (C), then install the harness clamp (D), and connect the B terminal and BLK wire (E). Make sure the crimped side of the B terminal is facing out.
2. Install the automatic transmission fluid (ATF) dipstick.
3. Connect the positive cable to the battery first, then connect the negative cable.
4. Start the engine to make sure the starter works properly.
5. Enter the anti-theft codes for the audio unit (and navigation code if equipped), then enter the audio presets.
6. Do the power window control unit reset procedure.
7. Set the clock.