DTC 62-1x
DTC 62-1x ("x" can be 0 thru 9 or A thru F): Open in the Front Passenger's Seat Belt Buckle SwitchNOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information.
1. Clear the DTC memory.
2. Turn the ignition switch to ON (II), then buckle and unbuckle the driver's seat belt several times.
3. Read the DTC.
Is DTC 62-1x indicated?
YES - Go to step 4.
NO - Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.
4. Disconnect the front passenger's seat subharness 3P connector from the front passenger's seat belt buckle switch 3P connector (A).
5. From the system selection menu on the HDS, select SRS, then select SRS again, then select PARAMETER INFORMATION, then Buckle Switch. Seat Position Sensor, and check the status on the HDS screen for FRONT RIGHT SEAT BELT BUCKLE SWITCH when the seat belt is buckled, and unbuckled.
- If UNBUCKLE, BUCKLE, or SHORT is indicated open in the front passenger's seat subharness, or floor wire harness; replace the faulty harness.
- If OPEN is indicated, go to step 6.
6. Measure the resistance between the No. 1 terminal of the front passenger's seat subharness 3P connector and body ground. There should be 0 - 1 ohm.
Is the resistance as specified?
YES - Go to step 7.
NO - Open in the front passenger's seat subharness, or floor wire harness or poor ground connection at G552. If G552 is OK, replace the faulty harness.
7. Alternately connect the No. 2 and the No. 3 terminals of the front passenger's seat subharness 3P connector to body ground with a jumper wire, and check the status on the HDS screen.
Does the status alternate from UNBUCKLE to BUCKLE?
YES - Replace the front passenger's seat belt buckle assembly, then clear the DTC.
NO - Open in the front passenger's seat subharness, or floor wire harness; replace the faulty harness.