Navi System Link

Navi System Link

- This diagnostic step tests the cables connecting the navigation components. Ensure that the ignition switch is in the ON (II) position. When the diagnosis begins, you hear a bong sound. The system is in a Detecting mode, and is waiting for all items in white to be tested. This includes the voice control switch (TALK/BACK buttons), and the microphone. Press the TALK button on the steering wheel, and in a normal voice, say testing. The TALK indicator on the screen should turn green, and the voice level indicator should move to at least the 6th bar to pass. Next, press the BACK button. The Cancel indicator should turn green.
- If all of the communication lines connecting the system components, and the TALK/BACK buttons/microphone check out OK (all block diagram items are green), then the OK indicator turns green.
- If there is a problem with the system, the faulty system component item turns red, and the screen will show NG in red. Use the troubleshooting index, and other diagnostic screens to help locate the problem.
- The indicator on the screen may not change until you cycle the ignition switch. After repairing the affected cable or system, repeat this diagnostic.

NOTE: Green boxes and green a OK indicate that the communications lines (cables) are intact. This diagnostic does not necessarily imply that the individual components are functioning properly. For instance, the GPS antenna wire may be crushed, but still show as green. A road test, or other diagnostic may be necessary to find the problem.

- Select Return to return to the Diagnostic Menu, or the Exit Diag button to exit.

NOTE: The Mic Level indicator must reach the 6th bar or greater to pass the test.