Dashboard Replacement

Dashboard Replacement

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

NOTE:
- Have an assistant help you when removing and installing the dashboard.
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Take care not to scratch the dashboard and related parts.

1. Remove these items:
- Center upper dashboard panel
- Driver's vent panel
- Dashboard center vent
- Passenger's vent panel
- Passenger's airbag
- Glove box
- Instrument panel
- Gauge control module
- Navigation unit, with navigation system
- Audio unit, without navigation system

Driver's side

2. Remove the screws, then remove the GPS antenna (A), then pull the antenna out through the hole in the dashboard.






3. Detach the wire harness clips (A) from the shift lever panel opening.






4. From the back of the dashboard, disconnect the tweeter connectors (A), then detach the wire harness clips (B).






Passenger's side

5. Carefully pry the glove box light (A) from the inside of the dashboard, and detach the wire harness clips (B).






6. From the back of the dashboard, remove the screws and center joint duct (A).






7. From the front of the dashboard (A), remove the screws.






8. Assemble the dashboard and steering hanger beam in the reverse order of removal, and note these items:

NOTE:
- Make sure the dashboard wire harness is not pinched.
- Make sure the connectors are plugged in properly.