Tire Pressure Sensor Location
Tire Pressure Sensor LocationSpecial Tools Required
TPMS sensor initializer tool AKS0620006
Available through the American Honda Tool and Equipment Program; call 1-888-424-6857
NOTE: This procedure locates where the tire pressure sensors number 1, 2, 3, 4 are mounted, when activated by the TPMS sensor initializer tool.
^ Memorizing tire pressure sensor IDs (including replacing the TPMS control unit, or the tire pressure sensors).
^ Wheel rotation.
1. With the ignition switch at LOCK (0), connect the HDS to the data link connector (DLC (A) located under the driver's side of the dashboard.
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehicle and the TPMS control unit. If it doesn't, troubleshoot the DLC circuit.
4. Select Function Test from the mode menu, then select Sensor Position Check on the HDS.
5. Follow HDS screen prompts to turn on the TPMS sensor initializer tool (A). Verify the power switch (B) is in the "Low" position.
6. Follow the prompts on the HDS to activate the tire pressure sensors using the TPMS sensor initializer tool. Start with the left-front (LF) wheel.
7. Check the HDS screen, and note the active sensor reception order of the tire pressure sensor 1, 2, 3, 4.
NOTE: If the sensor does not respond to the TPMS initializer, rotate the tire 1/4 turn and retry. If the sensor still does not respond after one full rotation of the tire, swap the tire to a known-good location and retry. If the sensor still does not respond after one full rotation of the tire, replace the tire pressure sensor.
8. Note the sensor location for reference.
9. Turn the ignition switch to LOCK (0).