Audio Unit Removal/Installation

Audio Unit Removal/Installation

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures in the SRS before doing repairs or service.

NOTE:
- Eject all the CDs before remove the audio unit to prevent damaging the CD player's load mechanism.
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
- If you are replacing the audio unit, write down the audio presets (if possible), and enter them into the new audio unit.

1. Make sure you have the anti-theft code for the audio system.
2. Remove the dashboard center panel.
3. Remove the four mounting bolts, then remove the audio unit.
4. Disconnect the audio connectors (A) and AM/FM antenna sublead (B).






5. Remove the eight mounting bolts securing the audio unit to the audio unit bracket.
6. Install the audio unit in the reverse order of removal, and note these items:
- Make sure the audio unit connector is plugged in properly, and the AM/FM antenna sublead is connected properly.
- Enter the anti-theft code for the audio system.
- Set the clock.