Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Pulley Removal and Installation

Special Tools Required
^ Socket, 19 mm 07JAA-001020A or a commercially available 19 mm socket
^ Holder handle 07JAB-001020B
^ Holder attachment, 50 mm 07NAB-001040A

Removal

1. Remove the right front wheel.
2. Remove the splash shield.
3. Remove the drive belt.
4. Hold the crankshaft pulley with holder handle (A) and holder attachment (B).





5. Remove the bolt with a 19 mm socket (C) and breaker bar, then remove the crankshaft pulley.

Installation

1. Clean the crankshaft pulley (A), crankshaft (B), bolt (C), and washer (D). Lubricate with the new engine oil as shown.





2. Install the crankshaft pulley, and hold the pulley with holder handle (A) and holder attachment (B).





3. Torque the bolt to 50 Nm (5.0 kgf-m, 37 lbf-ft) with a torque wrench and 19 mm socket (C). Do not use an impact wrench.
4. Mark the bolt head (A) and the crankshaft pulley (B) as shown, then torque the bolt an additional 90° (The mark on the bolt head lines up with the mark on the crankshaft pulley).





5. Install the drive belt.
6. Install the splash shield.
7. Install the right front wheel.