General Specifications
Cylinder HeadTorque 40 Nm (4.0 kgf-m, 29 lbf-ft)
Tighten in two steps 90° per step
New bolt torque an extra 90°
Measure the diameter of each cylinder head bolt at point A and point B.
If either diameter is less than 10.6 mm (0.42 in.), replace the cylinder head bolt.
Surface Variation
Warpage less than 0.05 mm (0.002 in.) no resurfacing
Warpage is between 0.05 mm (0.002 in.) to 0.2 mm (0.008 in.) resurface
Max. resurface limit 0.2 mm (0.008 in.)
based on a height of 104 mm (4.09 in.).
Intake Manifold
Torque the bolts/nuts in a crisscross pattern in three steps, beginning with the inner bolt.
Camshaft Bearing Cap
Camshaft Gear/Sprocket
Exhaust Manifold
Torque the bolts/nuts in a crisscross pattern in two or three steps, beginning with the inner bolt.