Oil Pan Installation
Oil Pan Installation1. Remove all of the old liquid gasket from the oil pan mating surfaces, bolts, and bolt holes.
2. Clean and dry the oil pan mating surfaces.
3. Apply liquid gasket, P/N 08717-0004, 08718-0001, 08718-0003, or 08718-0009, evenly to the engine block mating surface of the oil pan and to the inner threads of the bolt holes. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
^ If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
^ If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
4. Install the oil pan.
5. Torque the bolts/nuts in three steps. In the final step, torque all bolts, in sequence, to 12 Nm (1.2 kgf-m, 8.8 lbf-ft).
6. M/T model: Install the clutch cover.
7. If the engine is still in the vehicle, install the subframe.
- 1 Support the subframe with the subframe adapter and a jack, and lift it up to the body, then loosely install the new subframe mounting bolts.
- 2 Align the reference marks with the center of the subframe mounting bolts, then torque the bolts to the specified torque.
- 3 A/T model: Install the automatic transmission fluid (ATF) filter mounting bolt.
- 4 Torque the rear mount mounting bolts.
- 5 Torque the front mount mounting bolt.
- 6 Connect the suspension knuckle ball joints.
8. After assembly, wait at least 30 minutes before filling the engine with oil.