Removal and Replacement
Starter Removal and InstallationREMOVAL
1. Make sure you have the anti-theft code for the audio system.
2. Disconnect the negative cable from the battery.
3. Remove the intake manifold.
4. Disconnect the starter cable (A) from the B terminal, and disconnect the connector (B) from the solenoid S terminal.
5. Remove the harness clamp (C) and the harness holder (D).
6. Remove the two bolts holding the starter, then remove the starter.
INSTALLATION
1. Install the starter, then install the harness holder (A) and the harness clamp (B), connect the starter cable (C) to the B terminal, and the connector (D) to the solenoid S terminal. Make sure the crimped side of the ring terminal faces away from the starter when you connect it.
2. Install the intake manifold.
3. Connect the negative cable to the battery.
4. Start the engine to make sure the starter works properly.
5. Enter the anti-theft code for the audio system.
6. Do the power window control unit reset procedure.
7. Set the clock.