Oil Seal Replacement
Oil Seal ReplacementSpecial Tools Required
^ Oil seal driver 07GAD-PH70201
^ Oil seal driver 07JAD-PL90100
^ Attachment, 78 x 80 mm 07NAD-PX40100
^ Driver 07749-0010000
1. Remove the oil seals (A) from the rear differential carrier assembly.
NOTE: Be careful not to damage the differential carrier while prying out the seals.
2. Install the right side oil seal (A) squarely using the 78 x 80 mm attachment (B) and driver (Q. Installation depth of the oil seal is 9 mm (0.35 in.) below the machined edge of the rear differential carrier assembly. Be careful not to damage the lip of the oil seal.
3. Install the left side oil seal (A) squarely and flush with the machined edge of the rear differential carrier assembly using the oil seal driver (B). Be careful not to damage the lip of the oil seal.
4. Remove the companion flange.
5. Remove the oil seal (A) from the torque control differential case (B).
NOTE: Be careful not to damage the shaft or case while prying out the oil seal.
6. Install the oil seal (A) squarely using the oil seal driver (B). Be careful not to damage the lip of the oil seal.
7. Install the companion flange.