Mainshaft Bearing and Oil Seal Replacement
Mainshaft Bearing and Oil Seal ReplacementSpecial Tools Required
^ Oil seal driver 07JAD-PL90100
^ Adjustable bearing puller, 20-40 mm 07736-A01000B
^ Attachment, 42 x 47 mm 07746-0010300
^ Driver 07749-0010000
^ Slide hammer, 3/8"-16 UNF commercially available
1. Remove the ball bearing (A) from the clutch housing (B) using the 20-40 mm adjustable bearing puller (C) and a commercially available 3/8"-16 UNF slide hammer (D).
2. Remove the 28 x 43 x 7 mm oil seal (A) from the transmission side. Be careful when removing the seal so the clutch housing is not damaged.
3. Drive in the new 28 x 43 x 7 mm oil seal from the transmission side using the 42 x 47 mm attachment (A) and driver (B).
4. Drive in the new ball bearing (A) from the transmission side using the oil seal driver (B).
