B1282

DTC B1282: Windshield Wiper Switch INT (AUTO) Position Circuit Malfunction

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.
2. Turn the ignition switch to LOCK (0), and then back to ON (II).
3. Turn the windshield wiper switch in INT (AUTO) and wait for 2 seconds.
4. Check for DTCs with the HDS.

Is DTC B1282 indicated?

YES - Replace the windshield wiper/washer switch.

NO - Intermittent failure, the windshield wiper/washer switch and the combination switch control unit are OK at this time. Check for loose or poor connections.