Interior - Gap Between R/H Air Bag And Dashboard
09-017April 13, 2010
Applies To:
2008-10 Odyssey - ALL
Gap Between the Front Passenger's Airbag Lid and the Dashboard
(Supersedes 09-017, dated October 9, 2009, to revise the information marked by the asterisks)
*REVISION SUMMARY
In Applies To, 2010 models were added.*
SYMPTOM
There is a noticeable gap between the front passenger's airbag lid and the dashboard.
PROBABLE CAUSE
The front passenger's airbag lid is not aligned with the dashboard.
CORRECTIVE ACTION
Add washers to the airbag studs, and replace the front passenger's airbag lid.
PARTS INFORMATION
Passenger's Airbag Lid (graphite black):
P/N 77821-SHJ-A70ZA
Passenger's Airbag Lid (dark atlas gray):
P/N 77821-SHJ-A70ZB
6 mm Washer (three required):
P/N 94103-06800
REQUIRED MATERIALS
3M Weatherstrip Adhesive: P/N 08008
WARRANTY CLAIM INFORMATION
The normal warranty applies.
Operation Number 754110
Flat Rate Time: 0.3 hour
Failed Part: P/N 77821-SHJ-A70ZA
Defect Code: 00401
Symptom Code: 00101
Skill Level: Repair Technician
REPAIR PROCEDURE
1. Remove the front passenger's airbag, and replace the lid:
^ Refer to page 24-216 of the 2007-2010 Odyssey Service Manual, and do steps 1 thru 7 of the Removal, or
^ Online, enter keyword PASS REP, select Front Passenger's Airbag Replacement from the list, and do steps 1 thru 7 of the Removal.
NOTE:
The front passenger's airbag mounting nuts are covered by an access panel. Remove the access panel to remove the nuts.
2. Inspect the two notches on the dashboard opening for flashing. If there is flashing, use a utility knife to remove it.
3. Place one washer on each stud of the airbag.
NOTE:
Apply a drop of 3M Weatherstrip Adhesive by each stud to help hold the washer to the airbag.
4. Reinstall the passenger's front airbag:
^ Refer to page 24-218 of the service manual, and do steps 1 thru 5 of the Installation, or
^ Online, enter keyword PASS REP, select Front Passenger's Airbag Replacement from the list, and do steps 1 thru 5 of the Installation.