General Specifications
Cylinder HeadJ35A6 Engine
Tighten the cylinder head bolts in sequence to 29 Nm (3.0 kgf-m, 22 lbf-ft).
After torquing, tighten all cylinder head bolts in two steps (90° per step). If you are using a new cylinder head bolt, tighten the bolt an extra 90°.
Measure the diameter of each cylinder head bolt at point A and point B.
If either diameter is less than 11.3 mm (0.44 in.), replace the cylinder head bolt.
J35A7 Engine
Tighten the cylinder head bolts in sequence to 30 N-m (3.0 kgf-m, 22 lbf-ft)
After torquing, tighten all cylinder head bolts in two steps (90° per step). If you are using a new cylinder head bolt, tighten the bolt an extra 90°.
Measure the diameter of each cylinder head bolt at point A and point B.
If either diameter is less than 10.6 mm (0.42 in.), replace the cylinder head bolt.
Surface Variation
If warpage is less than 0.05 mm (0.002 in.), cylinder head resurfacing is not required.
If warpage is between 0.05 mm (0.002 in.) and 0.2 mm (0.008 in.), resurface the cylinder head.
Maximum resurface limit is 0.2 mm (0.008 in.) based on a height of 121 mm (4.76 in.).
Intake Manifold
Tighten the bolts and nuts sequentially in three steps.
Camshaft Gear/Sprocket
J35A6 Engine
J35A7 Engine
Front
Rear
