General Specifications
Cylinder HeadJ35A6 Engine
Tighten the cylinder head bolts in sequence to 29 Nm (3.0 kgf-m, 22 lbf-ft).
After torquing, tighten all cylinder head bolts in two steps (90° per step). If you are using a new cylinder head bolt, tighten the bolt an extra 90°.
Measure the diameter of each cylinder head bolt at point A and point B.
If either diameter is less than 11.3 mm (0.44 in.), replace the cylinder head bolt.
J35A7 Engine
Tighten the cylinder head bolts in sequence to 30 N-m (3.0 kgf-m, 22 lbf-ft)
After torquing, tighten all cylinder head bolts in two steps (90° per step). If you are using a new cylinder head bolt, tighten the bolt an extra 90°.
Measure the diameter of each cylinder head bolt at point A and point B.
If either diameter is less than 10.6 mm (0.42 in.), replace the cylinder head bolt.
Intake Manifold
Tighten the bolts and nuts sequentially in three steps.
Main Bearing
Tighten the bearing cap bolts, and then the bearing cap side bolts, in the sequence as shown. Repeat the torque sequence again to ensure the bolts are properly torqued.
Rod Bearing
Tightening Torque 20 N-m (2.0 kgf-m, 15 lbf-ft) + 90°
Mark the connecting rod (A) and the bolt head (B) as shown.
Tighten the bolt until the mark on the bolt head lines up with the mark on the connecting rod (turn the bolt 90°).
Crankshaft Pulley
Torque 64 N-m (6.5 kgf-m, 47 lbf-ft)
Tighten the bolt an additional 60°
Oil Pump
Water Pump
