Power Switch Will Not Turn On (No Information Display and No Sound)

Power switch will not turn ON (No information display and no sound)

NOTE: Check the vehicle battery condition first.

1. Turn the ignition switch ON (II).
2. Push the power switch ON to see if audio unit turns ON.

Does the audio unit operate properly, and does the audio sound normal?

YES - Intermittent failure, the system is OK at this time.

NO - Go to step 3.

3. Turn the ignition switch OFF.
4. Check the No.48 (20 A) fuse in the under-hood fuse/relay box and No.9 (15 A) fuse in the passenger's under-dash fuse/relay box.

Are the fuses OK?

YES - Go to step 5.

NO - Replace the fuse, and recheck.

5. Remove the audio unit. Check that the audio unit is properly connected.

NOTE: Eject all the discs before removing the audio unit to prevent damaging the CD player's load mechanism.

Is it connected properly?

YES - Go to step 6.

NO - Reconnect the connector, and recheck the function.

6. Turn the ignition switch ON (II).
7. Measure the voltage between the No.2 and No.10 terminals of the audio unit connector A (20P) and body ground.






Is there battery voltage?

YES - Go to step 8.

NO - Repair open in the wire(s) between the No.48 (20 A) fuse in the under-hood fuse/relay box. No.9 (15 A) fuse in the passenger's under-dash fuse/relay box and the audio unit.

8. Measure the voltage between audio unit connector A (20P) No. 20 terminal and body ground while pressing and releasing the audio unit power switch several times.






Is there less than 0.1 V?

YES - Replace the audio unit.

NO - Repair open in the wire between the audio unit connector A (20P) No. 20 terminal and body ground (G504).