General Specifications

Cylinder Head

Torque 30 N-m (3.0 kgf-m, 22 lbf-ft)





After torquing, torque all cylinder head bolts in two steps (90° per step). If you are using a new cylinder head bolt, torque the bolt an extra 90°.





Measure the diameter of each cylinder head bolt at point A and point B.





If either diameter is less than 10.6 mm (0.42 in.), replace the cylinder head bolt.

Surface Variation

Warpage less than 0.05 mm (0.002 in.) no resurfacing

Warpage is between 0.05 mm (0.002 in.) and 0.2 mm (0.008 in.) resurface

Max. resurface limit 0.2 mm (0.008 in.)
based on a height of 121 mm (4.76 in.).





Intake Manifold

Torque the bolts and nuts sequentially in three steps.





Camshaft Gear/Sprocket

J35A9 Engine





J35Z1 Engine

Front





Rear