Park Pin Switch Test

Park Pin Switch Test
SRS components are located in this area. Review the SRS component locations and the precautions and procedures in the SRS before doing repairs or service.

1. Remove the steering column covers.
2. Disconnect the park pin switch connector.
3. Shift the shift lever into the P position, and check for continuity between park pin switch connector terminals No. 1 and No. 3. There should be no continuity.





4. Shift out of the P position, and check for continuity between connector terminals No. 1 and No. 3. There should be continuity.
5. If the park pin switch is fails the test, replace the shift lever assembly. The park pin switch is not available separately from the shift lever assembly.