Cowl Moulding / Trim: Service and Repair

Cowl Cover Replacement

Special Tools Required

KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

NOTE:
- Take care not to scratch the cowl cover and body.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

1. Remove the windshield wiper arms.




2. Using a trim tool, detach the clips (A), then remove the hood rear seal (B) from the passenger's cowl cover (C). Disconnect the windshield washer tube (D), and remove the clips (E).




3. Detach the clips by carefully pulling the passenger's cowl cover (A) upward, and release the hook (B) on the passenger's cowl cover from the driver's cowl cover (C). Pull the cover forward to release the hook (D), and pull the hinge cover (E) out from the front fender (F) and windshield molding (G).
4. Disconnect the washer tube (H), then remove the passenger's cowl cover.




5. Remove the clips (A). Detach the clips (B) and hooks (C) by carefully pulling the driver's cowl cover (D) upward. Pull the cover forward to release the hooks (E), and pull the hinge cover (F) out from the front fender (G) and windshield molding (H).
6. If necessary, using a trim tool, detach the clips (I), then remove the hood rear seal (J) from the driver's cowl cover.
7. Install the covers in the reverse order of removal, and note these items:
- Check if the clips is damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.
- Make sure the washer tubes are connected securely.