Rear Seat Cushion Pivot Cable
Rear Seat Cushion Pivot Cable ReplacementSpecial Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
NOTE:
- Take care not to tear the seams or damage the seat covers.
- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- The left seat cushion is shown; the right seat cushion is similar.
1. Remove the rear seat assembly.
2. Remove the seat cushion.
3. Remove these items:
- Recline outer cover
- Rear seat cushion under-cover trim
- Rear seat cushion under-cover
4. Release the hooks (A), and pull back the seat cushion cover (B).
5. Release the tabs (A) and clip, then remove the pivot outer cover (B) and pivot inner cover (C).
6. Remove the rear seat cushion pivot cable (A).
1. Remove the lock washer (B), then disconnect the cable, and detach the cable clip (C).
2. Remove the screws (D), then remove the cable joint(E).
3. Remove the nut (F), then remove the cable guide (G) and inner mounting bracket (H), and disconnect the cable from the cable guide.
7. Install the pivot cable in the reverse order of removal, and note these items:
- Make sure the pivot cable is connected securely.
- Replace the lock washer with new one.