A/T Clutch Pressure Control Solenoid Valve A and B Replacement
A/T Clutch Pressure Control Solenoid Valve A and B Replacement1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
2. Disconnect the negative cable from the battery, then disconnect the positive cable.
3. Remove the battery hold-down bracket, and remove the battery and the battery tray.
4. Remove the intake manifold cover, the intake air duct, the resonator, and the air cleaner housing.
5. Remove the battery base and the battery base bracket.
6. Remove the nuts securing the shift cable bracket (A).
7. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
8. Remove the bolt securing the harness cover (A).
9. Remove the harness clamp (B) from the harness cover/clamp bracket (C), disconnect the 4th clutch transmission fluid pressure switch connector (D), then remove the harness cover from the bracket.
10. Disconnect the A/T clutch pressure control solenoid valve A connector (E), the A/T clutch pressure control solenoid valve B connector (F), the solenoid harness connector, the transmission range switch connector, the ATF temperature sensor connector, the output shaft (countershaft) speed sensor connector, the input shaft (mainshaft) speed sensor connector, and the 3rd clutch transmission fluid pressure switch connector.
11. Remove A/T clutch pressure control solenoid valves A and B, ATF pipes (C), gasket (D), and O-rings (E).
12. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust and dirt, and clean the passage if necessary.
13. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing. Install new O-rings over the ATF pipes.
14. Install A/T clutch pressure control solenoid valves A and B.
15. Install the harness cover on the cover bracket, and secure it with the bolt.
16. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely. Install the harness clamp on the bracket.
17. Attach the shift cable end to the control lever, then insert the control pin into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
18. Secure the shift cable bracket with the nuts.
19. Install the battery base bracket and the battery base.
20. Install the air cleaner housing, the resonator, the intake air duct, and the intake manifold cover.
21. Install the battery tray, the battery, and the battery hold-down bracket, then reconnect the battery cables.
22. Enter the anti-theft codes for the audio system and the navigation system (if equipped). Set the clock (on vehicles without navigation).
23. Do the power window control unit reset procedure.